We are offering disc clutches, disc brakes, industrial disc brakes,
adjustable disc clutches, pneumatic industrial clutches, industrial disc
clutches which have following features:
Features :-
- Saturated.
- Maintenance and adjustment free.
- With slip-rings for wet operation.
- Long life.
- Adjustable without dismantling - simple wear compensation adjustment.
- High operating frequency and fast switching times.
- High operating reliability.
These are also multi disc units and are used in oil immersed
conditions only. Used mainly in machine tools and do not require any
adjustment for wear during use.
Operating Features
The Wichita Air-Tube Disc Clutch combines all the best features of the disc
type clutch with all the advantages of direct air engagement. The simplest
and most trouble-free method of applying air pressure is through direct
axial pressure application by compressed air in a special composition
full-circle tube.
The lining is woven in one piece on massive looms, under proper
tension to insure a tightly woven superior quality product. Impregnated by
vacuum process with high heat resisting compound, cured under tremendous
heat and pressure, and specially treated, Lining is impervious to water, oil
and grease. Abrasive-free fiber, wire insertion with infusible resins, tight
weave, and pressure curing eliminate flange scoring tenden-cies and assure
longer life.
Brake blocks are formed to the precise arc of the flanges, are easy to
install, and can be counted on to conform to the flanges during a long life
of dependable performance. They are recommended for deepest well digging
under all conditions. New Drawworks – Our engineering department keeps
abreast of the latest engineering developments in draw-works.
We are in a position to furnish the proper size brake blocks for newest
type drilling rigs. Brake Blocks are drilled to fit each individual draw
works and are also available undrilled.
This oil and abrasion resistant pneumatic tube can be inflated up
to 200 psi against the outside diameter of the connecting pipe.
Seal-O-Grips Unions are used for speedy connect-and-disconnect of mud
suction and return lines or other low-pressure fluid lines. A tight seal is
maintained even if the pipe is mis-aligned within certain limits. Available
for popular oilfield line pipe sizes: 4, 6, 8 & 10 inch. The Seal-O-Grip
body (ASTM A216 Grade WCB carbon steel) welds in place on mud tanks,
manifold pipe and other fittings. The oil-resistant inflatable tube is heavy
duty, abrasion-resistant and is designed for 200 psi maximum air pressure.
(Note: Tube inflation pressure must exceed fluid line pressure by 50 psi to
seal line pressures up to 150 psi.)
Pneuflex rotor seals allow passage of pressurized fluids from a
stationary inlet to a rotating shaft end. Single, dual and triple passage
rotor seals are available in a variety of sizes and designs to meet most
flow requirements. The multiple passage units can be used for individual
control of components mounted on the same shaft, component lubrication and
circulating fluid systems.
